Packet loss impacts a network in two ways: it reduces throughput and adds to latency.
But why does packet loss occur in the first place?
The following excerpt from Panduit’s “What is the Impact of Packet Loss?” white paper focuses on the root causes of packet corruption and its prevention.
Corrupted packets can occur when they encounter a bit error as the packet moves from one end of the network to the other. Bit errors almost always occur in the lowest layer of a protocol stack, the physical layer. The job of the physical layer is to move information from one end of the network to the other.
Typically this information is represented by a stream of 0s and 1s. The physical layer does not assign any meaning to the stream of 0s and 1s because the upper layers handle that task.
Causes of Bit Errors
Copper Cabling/Wireless Connection: Outside interference such as lightning or other electrical noise can cause the bit error if the physical layer uses copper cabling or wireless connection.
Optical Networks: In optical networks, a bit error could occur if the optical module fails, causing it to have difficulty determining the stream of 0s and 1s. Other causes could be improperly terminated cabling, dirty fiber optic connectors, or water penetrating the cable.
Preventing Packet Loss
Proper Installation and Maintenance of the Network: When installing RJ45 jacks, you may untwist the copper pairs more than needed. This could unbalance the pair, allowing electromagnetic interference (EMI) to impact link performance. Cleaning the end-face of fiber optic connectors is always important, but even more so at higher network speeds.
Proper grounding and bonding eliminate differing ground potentials between different pieces of networking equipment. These are examples that impact the receiver’s ability to distinguish the transmitted bit sequence that leads to corrupted packets.
Media Type: Media type, for example, copper or fiber, should also be considered. CAT6A unshielded twisted pair copper cabling is ideal for new installations, as it provides the best performance for most applications without the added expense of shielded cable. For harsh environments where EMI is present, you may need to install shielded copper cable or fiber cabling, which are immune to EMI.
To learn more about how you can prevent good packets from going bad, download Panduit’s “What is the Impact of Packet Loss” white paper – or subscribe to our blog to receive our complete 4-part series of IoT 101 white papers.